1. Fold the sheet of paper in half vertically and horizontally.

2. Next, fold the top edge down to meet the center crease.

3. Again, take the top edge and fold to the center.

4. Repeat the previous step once again.

5. Measure one inch (2.5cm) to the left and right of the center line and draw vertical lines.

6. Now, measure 3 inches (7.6cm) from the bottom on both sides and draw a horizontal line.

7. Measure 1.5 inches (3.8cm) in from the horizontal line and draw vertical lines down to the bottom.

8. Next, connect the two points as shown in the image.

9. Cut out the shapes to leave only these two pointy pieces for the tail.

10. Fold the plane in half towards you and cut along the dotted line, about 1/2 inch (1.3cm) down from the corner.

11. Now, fold the wings out along the lines as shown and flip the thin tail stabilizer up.

12. Finally, glue or tape the nose of the plane and both ends of the wings.